Mitsubishi Electric Q26UD(E)HCPU - Page 354

352
2401
[FILE SET ERROR]
Program memory capacity was exceeded by
performing boot operation or automatic write to the
standard ROM.
■Collateral information
• Common information: File name/Drive name
• Individual information: Parameter number
■Diagnostic timing
• At power-on/At reset/At writing to programmable
controller
• Check and correct the parameters (boot
setting).
• Delete unnecessary files in the program
memory.
• Choose "Clear program memory" for boot
in the parameter so that boot is started after
the program memory is cleared.
RUN: Off
ERR.:Flashing
CPU Status:Stop
Qn(H)
QnPH
QnPRH
[FILE SET ERROR]
Program memory capacity was exceeded by
performing boot operation.
■Collateral information
• Common information: File name/Drive name
• Individual information: Parameter number
■Diagnostic timing
• At power-on/At reset
• Check and correct the parameters (boot
setting).
• Delete unnecessary files in the program
memory.
• Choose "Clear program memory" for boot
in the parameter so that boot is started after
the program memory is cleared.
QnU
LCPU
[FILE SET ERROR]
The file specified by parameters cannot be made.
■Collateral information
• Common information: File name/Drive name
• Individual information: Parameter number
■Diagnostic timing
• At power-on/At reset/At writing to programmable
controller/STOP  RUN
• Read the individual information of the error
using the programming tool to identify the
numeric value (parameter No.). Check the
drive name, file name, and size of the
parameter corresponding to the value, and
correct it as necessary.
• Format the drive.
• Delete unnecessary files on the drive to
increase free space.
[FILE SET ERROR]
• Although setting is made to use the device data
storage file, there is no empty capacity required
for creating the device data storage file in the
standard ROM.
• When the latch data backup function (to
standard ROM) is used, there is no empty
capacity required for storing backup data in
standard ROM. (The parameter number
"FFFF
H
" is displayed for the individual
information of the error.)
■Collateral information
• Common information: File name/Drive name
• Individual information: Parameter number
■Diagnostic timing
• At power-on/At reset/At writing to programmable
controller/STOP  RUN
Secure the empty capacity of the standard
ROM.
[FILE SET ERROR]
• Standard RAM capacity is insufficient that error
history of the module cannot be stored.
• Standard RAM capacity is insufficient that the
file register data cannot be stored.
■Collateral information
• Common information: File name/Drive name
• Individual information: Parameter number
■Diagnostic timing
• At power-on/At reset/At writing to programmable
controller/STOP  RUN
Secure sufficient space in the standard RAM.
2406
[FILE SET ERROR]
When the extended data register and extended
link register are configured in the File Register
Extended Setting in the Device tab of "PLC
Parameter", the size of the file register file is
smaller than that specified in the PLC File tab.
■Collateral information
• Common information: File name/Drive name
• Individual information: Parameter number
■Diagnostic timing
•STOP  RUN
• Correct the size for the file register file in
the PLC File tab of "PLC Parameter".
• Correct the setting for the "File Register
Extended Setting" in the Device tab of
"PLC Parameter".
RUN: Off
ERR.:Flashing
CPU Status:Stop
QnU
LCPU
Error
code
Error and cause Corrective action
LED status,
CPU status
Corresponding
CPU