Mitsubishi Electric Q26UD(E)HCPU - Page 524

522
SD201 LED status
Status of
CPU-LED
• This register stores the LED status information on the CPU
module in the following bit pattern.
• 0 is off, 1 is on, and 2 is flashing.
1): RUN, 2): ERR., 3): USER
*1
, 4): BAT.
*1
, 5): BOOT
*1
, 6):
Empty
*1
, 7): Empty
*1
, 8): MODE
*1
(0: Off, 1: Green, 2: Orange)
*1 For the Basic model QCPU, 3) to 8) are left empty.
S (Status
change)
New
Q00J/Q00/Q01
Qn(H)
QnPH
QnPRH
• This register stores the LED status information on the CPU
module in the following bit pattern.
• 0 is off, 1 is on, and 2 is flashing.
1): RUN, 2): ERR., 3): USER, 4): BAT., 5): BOOT
*1
, 6): SD
CARD
*2
, 7): Empty, 8): MODE
*1 For the Q00UJCPU, Q00UCPU, and Q01UCPU, 5) is left
empty.
*2 For the CPU module other than the QnUDVCPU, 6) is left
empty.
QnU
• This register stores the LED status information on the CPU
module in the following bit pattern.
• 0 is off, 1 is on, and 2 is flashing.
1): RUN, 2): ERR., 3): USER, 4): BAT., 5): Empty, 6): Empty,
7): I/O ERR., 8): MODE
LCPU
SD202
LED off
command
Bit pattern of
LED that is
turned off
• By specifying the LEDs in this register and turning SM202
from off to on, the LEDs can be turned off. The USER and
BOOT
*1
LEDs can be specified.
• The LED to be turned off can be specified in the following bit
pattern. (Setting "1" turns off the LED and setting "0" does
not turn off the LED.)
*1 For the Q00UJCPU, Q00UCPU, and Q01UCPU, the
BOOT LED cannot be specified.
UNew
Qn(H)
QnPH
QnPRH
QnU
• By specifying the LEDs in this register and turning SM202
from off to on, the LEDs can be turned off. The USER LED
can be specified.
• The LED to be turned off can be specified in the following bit
pattern. (Setting "1" turns off the LED and setting "0" does
not turn off the LED.)
LCPU
Number Name Meaning Explanation
Set by
(When Set)
Corresponding
ACPU
D9
Corresponding
CPU
b15 b12 b11 b8 b7 b4 b3 b0
1)2)4) 3)5)6)8) 7)
to tototo
b15 b12 b11 b8 b7 b4 b3 b0
1)2)4) 3)5)6)8) 7)
to tototo
b15 b12 b11 b8 b7 b4 b3 b0
1)2)4) 3)5)6)8) 7)
to tototo
b15 b8 b4 b0
USER LED
BOOT LED
Fixed to 0
Fixed to 0 Fixed to 0
b15 b8 b4 b0
USER LED
Fixed to 0
Fixed to 0