Mitsubishi Electric Q26UD(E)HCPU - Page 545

543
APPENDICES
A
Appendix 3 List of Special Register Areas
SD636
Project data
batch load
error cause
Project data
batch load
error cause
This register stores the cause of an error occurred when the
batch load function is executed.
•0
H
: No error
• 800
H
: Mismatch of CPU module models
• 801
H
: Batch-save/load-target data read error (SD memory
card)
• 802
H
: SD memory card removed
• 803
H
: No system file (SVLDINF.QSL) existed
• 804
H
: Mismatch of file password 32
• 805
H
: No specified folder existed or specified number out-
of-range
• 810
H
: Load-destination drive write error
• 820
H
: Load error of a file in use
• 821
H
: Format was executed while a file that is being used
existed.
• 900
H
: SD memory card not inserted
• 901
H
: Use of SD memory card stopped
•A00
H
: Load-target data size exceeded the capacity of drive
or memory card
•B00
H
: Write protection set to SD memory card
•C00
H
: The batch load function was executed during the
latch data backup to the standard ROM.
•C01
H
: The batch load function was executed during online
change.
•C02
H
: The batch load function was executed with an FTP
client connected to and communicated with the CPU
module.
•C04
H
: The batch load function was executed while the CPU
module change function with SD memory card was being
executed.
•C07
H
: The batch load function was executed while the iQ
Sensor Solution function (data backup/restoration) was
being executed.
•C08
H
: The batch save function was executed while the file
transfer function (FTP client) was being executed.
•C10
H
: CPU module in RUN or PAUSE status
S (Error) New
LCPU
*5
SD637
Project data
batch load
status
Project data
batch load
status
This register stores the current status of the batch load
function.
•0
H
: Not executed
•1
H
: Being executed
•2
H
: Completed
•FF
H
: Error
S (Status
change)
New
LCPU
*5
SD638
Directory
batch delete
completion
status
Directory
batch delete
completion
status
This register stores the completion status of the directory
batch delete processing.
0: Normally completed
Other than 0: Error code
When the delete processing is instructed, "0" is set.
S (Writing) New QnUDV
SD639
Directory
batch
deletion
status
Directory
batch
deletion
status
The status of the directory batch delete processing is
indicated in percentage (0 or 100 %).
• When the delete processing is instructed, "0" is set.
S (Writing) New QnUDV
SD640
File register
drive
Drive number
This register stores the number of a drive storing a file
register.
*1
*1 For the QnUDVCPU or LCPU, this register is fixed at
drive 3.
S (Status
change)
New
Q00J/Q00/Q01
Qn(H)
QnPH
QnPRH
QnU
*3
LCPU
Number Name Meaning Explanation
Set by
(When Set)
Corresponding
ACPU
D9
Corresponding
CPU