Multi Information display - Type 1
5-144 Features and controls
N00529801302
The language used in Mitsubishi Multi-Com-
munication System (if so equipped) or Blue-
tooth
®
2.0 interface (if so equipped) can be
changed automatically to the same language
as that shown in the multi information dis-
play.
1. Press and hold the multi information dis-
play switch (for about 2 seconds or more)
to switch from the setting mode screen to
the menu screen. Refer to “Changing the
function settings” on page 5-140.
2. Lightly press the multi information dis-
play switch to select “ ” (language
cooperative control).
3. Press and hold the multi information dis-
play switch to switch from A/1 (language
cooperation: enabled) to M/2/P (language
cooperation: disabled), or from M/2/P to
A/1. The setting is changed to the selected
condition.
N00557401156
You can turn off the operation sounds of the
multi information display switch and rheostat
illumination button.
1. Press and hold the multi information dis-
play switch (for about 2 seconds or more)
to switch from the setting mode screen to
the menu screen.
Changing the language on Mit-
subishi Multi-Communication
System or Bluetooth
®
2.0 interface
to match the multi information
display
If the battery is disconnected, the language
cooperative control is automatically set to
“A or 1” (language cooperation: enabled).
The language cooperation setting can be
switched in the following manner.
• When “A or 1” (language cooperation:
enabled) has been selected, the language for
Mitsubishi Multi-Communication System
(if so equipped) or Bluetooth
®
2.0 interface
(if so equipped) is automatically changed to
the language selected for the multi informa-
tion display.
However, this changing function may not
work depending on the language selected
for the multi information display.
• When “M, 2 or P” (language cooperation:
disabled) has been selected, the language
for Mitsubishi Multi-Communication Sys-
tem (if so equipped) or Bluetooth
®
2.0
interface (if so equipped) is not automati-
cally changed to match the language
selected for the multi information display.
The language on the audio system’s display
does not automatically change when you
select A or 1 (language cooperation:
enabled) in the language cooperation control.
Operation sound setting
BK0223400US.book 144 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
