If the combination headlights and dimmer
switch is turned to the “ ” or “ ” posi-
tion again after the engine is turned off, the
about 3-minute auto-cutout function
described above will not work. The lights (the
parking lights, tail lights and license plate
lights) will stay on and will not turn off auto-
matically.
N00584500028
This warning light will illuminate when there
is a malfunction in the LED headlights.
N00549801236
[When using a key to start the engine]
If the driver’s door is opened with the key in
the “OFF” or “LOCK” or “ACC” position or
removed from the ignition switch while the
lights are on, the tone will sound to remind
you to turn off the lights.
[When using the F.A.S.T.-key to start the
engine]
If the driver’s door is opened with the opera-
tion mode is put in OFF or ACC, or if the
operation mode is changed to OFF while the
lights are on, the tone will sound to remind
you to turn off the lights.
In either case, the lights will turn off automat-
ically and so will the tone. Or you can turn
the light switch to the “OFF” position to stop
the tone.
N00549901178
To change the headlights from high beam to
low beam and vice versa, pull the turn signal
lever to (1). Switch the headlights to low
beam as a courtesy whenever there are
oncoming vehicles, or when there is traffic
moving ahead of you. An illuminated blue
light in the instrument cluster indicates when
the headlights are on high beam.
The light auto-cutout function can be deacti-
vated.
See your authorized Mitsubishi Motors
dealer for details.
For vehicles equipped with the Mitsubishi
Multi-Communication System, adjustments
can be made using screen operations. For
further details, refer to the separate owner’s
manual.
When you want to keep the lights
on:
LED headlight warning light (if
so equipped)
To Next Page
Loading...
Need help?
General
