Bluetooth® 2.0 interface (if so equipped)
Features and controls 5-201
4. The voice guide will say “Start pairing
procedure on the device. See the device
manual for instructions.” and then will
say “The pairing code is <pairing code>.”
5. Enter in the Bluetooth
®
device the 4-digit
number that has been read out in Step 4.
6. The voice guide will say “Please say the
name of the device after the beep.” You
can assign a desired name for the Blue-
tooth
®
device and register it as a device
tag. Say the name you want to register
after the beep.
The following procedure ( to ) can also
be used instead of saying “Pair Device.”
Replace this step 3 with the following proce-
dure if you prefer.
Say “Setup.”
Say “Pairing Options.”
The voice guide will say “Select one of
the following: pair, edit, delete, or list.”
Say “Pair.”
If 7 devices have already been paired, the
voice guide will say “Maximum devices
paired” and then the system will end the
pairing process. To register a new device,
delete one device and then repeat the pairing
process.
(Refer to “Selecting a device: Deleting a
device” on page 5-203.)
Some Bluetooth
®
devices require a specific
pairing code. Please refer to the device man-
ual for pairing code requirements and read
the next section “If your device requires a
specific pairing code” on page 5-202 to set
the pairing code.
The pairing code entered here is only used
for the Bluetooth
®
connection certification.
Depending on the connection settings of the
Bluetooth
®
device, this code may have to be
entered each time you connect the Blue-
tooth
®
device to the Bluetooth
®
2.0 inter-
face. For the default connection settings,
refer to the instructions for the device.
Depending on the Bluetooth
®
device, it may
take a few minutes to pair it with the Blue-
tooth
®
2.0 interface.
If the Bluetooth
®
2.0 interface cannot recog-
nize the Bluetooth
®
device, the voice guide
will say “Pairing has timed out” and the pair-
ing process will be cancelled.
Confirm that the device you are pairing sup-
ports Bluetooth
®
, and try pairing it again.
If you enter the wrong number, the voice
guide will say “Pairing failed” and the pair-
ing process will be cancelled.
Confirm the number is right, and try pairing
it again.
If your device requires a specific pairing
code, you need to set the pairing code. Refer
to the device manual for pairing code
requirements and read the next section “If
your device requires a specific pairing code”
on page 5-202.
When the confirmation function is on, after
repeating the device tag you have said, the
voice guide will ask “Is this correct?”
Answer “Yes.”
To change the device tag, answer “No” and
then say the device tag again.
BK0223400US.book 201 ページ 2015年2月13日 金曜日 午後12時15分