Screen type 1 Screen type 2 Cause Solution (Reference)
––
l
There is a fault in the electri-
cal system.
l
Immediately stop the vehicle
in a safe place.
We recommend you to con-
sult a MITSUBISHI
MOTORS Authorized Service
Point.
l
The engine is overheated.
l
Stop the vehicle in a safe
place and take corrective
measures.
Refer to “Engine overheat-
ing” on page 8-04.
l
The automatic transmission
(CVT) fluid temperature is
too high.
l
Refer to “Automatic transmis-
sion INVECS-III Sports
Mode 6CVT (Intelligent &
Innovative Vehicle Electronic
Control System III)” on page
6-20.
l
You turned the ignition switch
to the “ON” position or put
the operation mode in ON
without fastening your seat
belt.
l
Fasten your seat belt properly.
Refer to “Driver’s seat belt
warning lamp and display” on
page 4-11.
l
There is a fault in the fuel
system.
l
We recommend you to con-
sult a MITSUBISHI
MOTORS Authorized Service
Point.
Indication lamp, warning lamp, and information screen display list
5-35
OGAE19E1
Instruments and controls
5
To Next Page
Loading...
