EasyManua.ls Logo

Mitsubishi ASX 2019

Mitsubishi ASX 2019
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Retracting and extending the
outside mirrors
The outside mirror can be folded in towards
the side window to prevent damage when
parking in narrow areas.
CAUTION
l
Do not drive the vehicle with the mirror fol-
ded in.
The lack of rearward visibility normally pro-
vided by the mirror could lead to an acci-
dent.
[Except for vehicles equipped with the
mirror retractor switch]
Push the mirror towards the back of the vehi-
cle with your hand to retract it in. When ex-
tending the mirror, pull it out towards the
front of the vehicle until it clicks to lock in
place.
[For vehicles equipped with the mirror re-
tractor switch]
Retracting and extending the
mirrors using the mirror retrac-
tor switch
With the ignition switch or the operation
mode in ON or ACC, push the mirror retrac-
tor switch to retract the mirrors.
Push it again to extend the mirrors to their
original positions.
After turning the ignition switch to the
“LOCK” position or putting the operation
mode in OFF, it is possible to retract and ex-
tend the mirrors using the mirror retractor
switch for about 30 seconds.
CAUTION
l
It is possible to retract and extend the mir-
rors by hand. After retracting a mirror using
the mirror retractor switch, however, you
should extend it by using the switch again,
not by hand. If you extended the mirror by
hand after retracting it using the switch, it
would not properly lock in position. As a re-
sult, the mirror could move because of the
wind or vibration while you are driving, and
this may limit the driver’s rearward visibili-
ty.
NOTE
l
Be careful not to get your hands trapped
while a mirror is moving.
l
If you move a mirror by hand or it moves af-
ter hitting a person or object, you may not be
able to return it to its original position using
the mirror retractor switch. If this happens,
push the mirror retractor switch to place the
mirror in its retracted position and then push
the switch again to return the mirror to its
original position.
l
When freezing has occurred and mirrors fail
to operate as intended, please refrain from
repeated pushing of the retractor switch as
this action can result in burn-out of the mir-
ror motor circuits.
Outside rear-view mirrors
6-10
OGAE19E1
Starting and driving
6

Table of Contents

Related product manuals