Mitsubishi ASX 2019

Indication lamps
Turn-signal indication lamps/
Hazard warning indication
lamps
These indication lamps blink
in the following situations.
• When the turn-signal
lever is moved to ac-
tivate a turn-signal
lamp.
Refer to “Turn-signal
lever” on page 5-59.
• When the hazard
warning flasher
switch is pressed to
activate the hazard
warning lamps.
Refer to “Hazard
warning flasher
switch” on page
5-59.
• When the hazard
warning lamps auto-
matically activate due
to sudden braking
while driving.
Refer to “Emergency
stop signal system*”
on page 6-35.
NOTE
l
If these indication lamps blink too fast due
to any operation other than sudden braking,
the cause may be a blown lamp bulb or a
faulty turn-signal connection.
High-beam indication lamp
This indication lamp illumi-
nates when the high-beam is
used.
Front fog lamp indication
lamp*
This lamp illuminates while
the front fog lamps are on.
Rear fog lamp indication lamp
This lamp illuminates while
the rear fog lamp is on.
Position lamp indication lamp
This indication lamp illumi-
nates while the position
lamps are on.
Warning lamps
Brake warning lamp
This lamp illuminates when
the ignition switch is turned
to the “ON” position or the
operation mode is put in ON,
and goes off after a few sec-
onds.
Always make sure that the lamp goes off be-
fore driving.
With the ignition switch or the operation
mode in ON, the brake warning lamp illumi-
nates under the following conditions:
l
When the parking brake lever has been
engaged.
l
When the brake fluid level in the reser-
voir falls to a low level.
l
When the brake force distribution func-
tion is not operating correctly.
Indication lamps
5-46
OGAE19E1
Instruments and controls
5