Mitsubishi ASX 2019

NOTE
•
Automatically extend when the driver’s
door is closed and the ignition switch is
turned to the “ON” position.
In addition, automatically retract when the
ignition switch is turned to the “LOCK”
or “ACC” position, and the driver’s door
is then opened.
•
Automatically extend when the vehicle
speed reaches 30 km/h.
•
Deactivate the automatic extension func-
tion.
The outside rear-view mirrors can be retrac-
ted or extended by the following operations,
even if the functions have been modified as
stated above.
After pressing the LOCK switch to lock the
doors and tailgate, if the LOCK switch is
pressed again twice in a row within approxi-
mately 30 seconds, the outside rear-view
mirrors will retract.
After pressing the UNLOCK switch to un-
lock the doors and tailgate, if the UNLOCK
switch is pressed again twice in a row within
approximately 30 seconds, the outside rear-
view mirrors will extend again.
l
The remote control switch will operate with-
in approximately 4 m from the vehicle.
However, the operating range of the remote
control switch may change if the vehicle is
located near a power station, or radio/TV
broadcasting station.
l
If either of the following problems occurs,
the battery may be exhausted.
NOTE
•
The remote control switch is operated at
the correct distance from the vehicle, but
the doors and tailgate are not locked/
unlocked in response.
•
The indication lamp (3) is dim or does not
come on.
For further information, please contact
your MITSUBISHI MOTORS Authorized
Service Point.
If you replace the battery yourself, refer to
“Procedure for replacing the remote con-
trol switch battery” on page 3-07.
l
If your remote control switch is lost or dam-
aged, please contact your MITSUBISHI
MOTORS Authorized Service Point for a re-
placement remote control switch.
l
If you wish to add a remote control switch,
we recommend you to contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
A maximum of 8 remote control switches
are available for your vehicle.
Setting of door and tailgate un-
lock function (Except for vehi-
cles equipped with a Dead
Lock System)
The door and tailgate unlock function can be
set to the following two conditions.
Each time the door and tailgate unlock func-
tion is set, a chime will sound to tell you the
condition of the door and tailgate unlock
function.
Number of
chimes
Condition
One chime
When the UNLOCK switch
is pressed one time, all doors
and the tailgate unlock. [Fac-
tory setting]
Two chimes
When the UNLOCK switch
is pressed one time, only the
driver’s door unlocks. When
the UNLOCK switch is
pressed two times in succes-
sion, all doors and the tail-
gate unlock.
1. Remove the key from the ignition
switch.
2. Place the combination headlamps and
dipper switch in the “OFF” position, and
leave the driver’s door open.
3. Press and hold the LOCK switch (1) for
4 to 10 seconds and then also press the
UNLOCK switch (2) during this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of
pressing the LOCK switch in step 3.
Keyless entry system*
3-06
OGAE19E1
Locking and unlocking
3