Mitsubishi ASX 2019

CAUTION
l
Handle halogen lamp bulbs with care. The
gas inside a halogen lamp bulbs is highly
pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause it
to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the fog lamps are op-
erated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc., and
refit it after drying it thoroughly.
NOTE
l
When refitting the clip, first insert part (H)
of the clip into the hole and then press part
(I) into it.
Daytime running lamps* / Posi-
tion lamps (Type 2)*
NOTE
l
The daytime running lamps/position lamps
(Type 2) use an LED instead of a bulb.
Check with a MITSUBISHI MOTORS Au-
thorized Service Point when the lamp needs
to be repaired or replaced.
Rear fog lamp
NOTE
l
The rear fog lamp uses an LED instead of a
bulb. Check with a MITSUBISHI MOTORS
Authorized Service Point when the lamp
needs to be repaired or replaced.
Rear combination lamps
1. Remove the screws (A) that hold the
lamp unit and remove the lamp unit.
2. Turn the socket and bulb assembly anti-
clockwise to remove it.
Replacement of lamp bulbs
10-30
OGAE19E1
Maintenance
10