EasyManua.ls Logo

Mitsubishi ASX 2019

Mitsubishi ASX 2019
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
“For service A1/B1, A3/B3, A3/B4, or
A5/B5”
NOTE
l
Use of additives is not recommended since
they may reduce the effectiveness of addi-
tives already included in the engine oil. It
may result in failure of the mechanical as-
sembly.
Engine coolant
To check the coolant level
A transparent coolant reserve tank (A) is lo-
cated in the engine compartment.
The coolant level in this tank should be kept
between the “LOW” and “FULL” marks
when measured while the engine is cold.
To add coolant
The cooling system is a closed system and
normally the loss of coolant should be very
slight. A noticeable drop in the coolant level
could indicate leakage. If this occurs, we rec-
ommend you to have the system checked as
soon as possible.
If the level should drop below the “LOW”
level on the reserve tank, open the lid and
add coolant.
Also, if the reserve tank is completely empty,
remove the radiator cap (B) and add coolant
until the level reaches the filler neck.
WARNING
l
Do not open the radiator cap (B) while the
engine is hot. The coolant system is under
pressure and any hot coolant escaping
could cause severe burns.
Anti-freeze
The engine coolant contains an ethylene gly-
col anti-corrosion agent. Some parts of the
engine are cast aluminium alloy, and periodic
changing of the engine coolant is necessary
to prevent corrosion of these parts.
Use “MITSUBISHI MOTORS GENUINE
SUPER LONG LIFE COOLANT PREMI-
UM” or equivalent*.
*: similar high quality ethylene glycol based
non-silicate, non-amine, non-nitrate and non-
borate coolant with long life hybrid organic
acid technology.
MITSUBISHI MOTORS GENUINE Coolant
has excellent protection against corrosion and
rust formation of all metals including alumi-
nium and can avoid blockages in the radiator,
heater, cylinder head, engine block, etc.
Because of the necessity of this anti-corro-
sion agent, the coolant must not be replaced
with plain water even in summer. The re-
quired concentration of anti-freeze differs de-
pending on the expected ambient tempera-
ture.
Engine coolant
10-06
OGAE19E1
Maintenance
10

Table of Contents

Related product manuals