EasyManua.ls Logo

Mitsubishi ASX 2019

Mitsubishi ASX 2019
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alarm activation
When the system is in the system armed
mode, the alarm will be activated as follows
if the vehicle is unlocked or if any of the
doors, tailgate or bonnet is opened using a
method other than the keyless entry system or
the keyless operation function.
1. The alarm will be activated for approxi-
mately 30 seconds.
The turn-signal lamps will blink, and the
siren will sound intermittently.
2. The alarm will resume if unlawful ac-
tions are taken again, even if the alarm
has stopped.
NOTE
l
During an alarm operation, the alarm is dis-
played on the information screen in the mul-
ti-information display.
Type 1
Type 2
Cancelling the alarm
It is possible to halt the activation of an alarm
using the following methods:
l
Pressing the LOCK or UNLOCK switch
on the remote control switch.
(After pressing the LOCK switch, the
vehicle will lock if all the doors and the
tailgate are closed, after which the sys-
tem preparation mode will once again go
into effect.)
l
Turning the ignition switch to the “ON”
position (except for vehicles equipped
with the keyless operation system).
l
Putting the operation mode in ON (vehi-
cles equipped with the keyless operation
system).
l
Holding the keyless operation key and
locking and unlocking the doors and the
tailgate using the keyless operation func-
tion (vehicles equipped with the keyless
operation system).
NOTE
l
When the ignition switch is turned to the
“ON” position or the operation mode is put
in ON, the buzzer sounds 4 times. This oper-
ation indicates that the alarm was activated
while the vehicle was parked.
Please check the inside of the vehicle to con-
firm that nothing was stolen.
l
Even if the battery is disconnected, the alarm
activation memory will not be erased.
Electric window control
The electric windows can only be operated
with the ignition switch in the “ON” position
or the operation mode in ON.
WARNING
l
Before operating the electric window con-
trol, make sure that nothing can get trap-
ped (head, hand, finger, etc.).
Electric window control
3-38
OGAE19E1
Locking and unlocking
3

Table of Contents

Related product manuals