If you press the multi-information meter
switch, the display screen switches to the
screen that was displayed before the warning
display and the mark (A) is displayed.
NOTE
l
Warning display screens with a “ ” or “ ”
mark displayed in the upper right of the
screen can be switched. If you want to
switch the display, press the multi-informa-
tion meter switch as follows.
“ ”: Press lightly.
“ ”: Press for about 2 seconds or more.
Redisplay of a warning display
screen
When the mark is displayed, if you lightly
press the multi-information meter switch a
few times, the warning display screen you
switched from is displayed again.
Other interrupt displays
The operation status of each system is dis-
played on the information screen.
Refer to the appropriate page in the warning
display list for further details.
Refer to “Other interrupt displays” on page
5-42.
Selector lever position display
screen*
Shows the position of the se-
lector lever.
Refer to “Selector lever op-
eration” on page 6-20.
Outside temperature display
screen
This shows the temperature
outside the vehicle.
NOTE
l
The display setting can be changed to the
preferred units (°C or °F).
Refer to “Changing the function settings
(when the ignition switch or the operation
mode is ON)” on page 5-18.
l
Depending on factors such as the driving
conditions, the displayed temperature may
vary from the actual outside temperature.
Fuel remaining display screen
This displays the amount of fuel remaining.
CAUTION
l
Do not run out of fuel, or the catalytic con-
verter may be adversely affected. If the
warning display appears, refuel as soon as
possible.
Multi-information display
5-15
OGAE19E1
Instruments and controls
5
To Next Page
Loading...
