Mitsubishi ASX 2019

Screen type 1 Screen type 2 Cause Solution (Reference)
—
l
There is a fault in the Auto-
matic High-Beam (AHB) sys-
tem.
l
We recommend you to con-
sult a MITSUBISHI
MOTORS Authorized Service
Point.
Refer to “System problem
warning” on page 5-55.
Other interrupt displays
Screen type 1 Screen type 2 System operation status Reference
––
l
When starting the engine, you
pressed the engine switch
without depressing the clutch
pedal (M/T).
l
On vehicles with M/T, place
the gearshift lever in the “N”
(Neutral) position, fully de-
press the clutch pedal, depress
the brake pedal with the right
foot. Then, press the engine
switch. Refer to “Starting and
stopping the engine” on page
3-17.
––
l
When starting the engine, the
selector lever is in a position
other than the “P” (Park) or
the “N” (Neutral) position, or
you pressed the engine switch
without depressing the brake
pedal (A/T or CVT).
l
On vehicles with A/T or CVT,
place the selector lever in the
“P” (PARK) position, depress
the brake pedal with the right
foot. Then, press the engine
switch. Refer to “Starting and
stopping the engine” on page
3-17.
The operation status of each system is displayed on the information screen. Refer to the appropriate page for the system for further details.
Indication lamp, warning lamp, and information screen display list
5-42
OGAE19E1
Instruments and controls
5