Mitsubishi ASX 2019

CAUTION
l
Setting the drive mode-selector to “4WD
LOCK” to drive on dry paved road will in-
crease fuel consumption, with possible noise
and vibration generation.
Turning sharp corners
When turning a sharp corner in “4WD
LOCK” position at low speed, a slight differ-
ence in steering may be experienced similar
to as if the brakes were applied. This is called
tight corner braking and results from each of
the 4 tyres being at a different distance from
the corner. The phenomenon is typical of 4-
wheel drive vehicles. If this occurs, either
straighten out the steering wheel, or change
to “2WD” or “4WD AUTO” mode.
On snowy or icy roads
Set the drive mode-selector to “4WD AUTO”
or “4WD LOCK” in accordance with the
road conditions, and then gradually depress
the accelerator pedal for a smooth start.
NOTE
l
The use of snow tyres is recommended.
l
Maintain a safe distance between vehicles,
avoid sudden braking, and use engine brak-
ing (downshifting).
CAUTION
l
Avoid sudden braking, sudden acceleration
and sharp turning. Skidding occurs and con-
trol of the vehicle could be lost.
Driving on sandy or muddy
roads
Set the drive mode-selector to “4WD LOCK”
and then gradually depress the accelerator
pedal for a smooth start. Keep the pressure on
the accelerator pedal as constant as possible,
and drive at low speed.
CAUTION
l
Do not force the vehicle or drive recklessly
on sandy surfaces. In comparison with nor-
mal road surfaces, the engine and other
drive-system components are put under ex-
cessive strain when driving on such a sur-
face. This could lead to accidents.
l
If the engine coolant temperature display
flashes on the information screen in the mul-
ti-information display or the engine power
drops suddenly while the vehicle is being
driven, park your vehicle immediately in a
safe place.
Refer to “Engine overheating” on page
8-04 for details and take the required meas-
ures.
WARNING
l
When attempting to rock your vehicle out
of a stuck position, be sure that the area
around the vehicle is clear of people and
physical objects. The rocking motion may
cause the vehicle to suddenly launch for-
ward or backward, causing injury or
damage to nearby people or objects.
NOTE
l
Avoid sudden braking, sudden acceleration
and sharp turning; such operations could re-
sult in the vehicle becoming stuck.
l
If the vehicle becomes stuck in sandy or
muddy roads, it can often be moved with a
rocking motion. Move the selector lever al-
ternately between the “D” (DRIVE) and “R”
(REVERSE) positions while pressing lightly
on the accelerator pedal.
l
Driving on rough roads can cause rust on the
vehicle; wash the vehicle thoroughly as soon
as possible after such use.
Climbing/descending sharp
grades
Your vehicle may not provide sufficient hill
climbing ability and engine braking on steep
slopes. Avoid driving on steep slopes even
though the vehicle is a 4-wheel drive vehicle.
4-wheel drive operation
6-30
OGAE19E1
Starting and driving
6