Mitsubishi ASX 2019

CAUTION
l
Do not perform the following operation
while the hill start assist is operating.
[Except for vehicles equipped with keyless
operation system]
Turn the ignition switch to the “LOCK” or
“ACC” position.
[Vehicles equipped with keyless operation
system]
Put the operation mode in OFF or ACC.
The hill start assist could stop operating,
which could result in an accident.
To operate
1. Stop the vehicle completely using the
brake pedal.
2. On vehicles equipped with M/T, place
the gearshift lever into the 1
st
position.
On vehicles equipped with CVT, place
the selector lever into the “D” position.
NOTE
l
When reversing on an uphill slope, place the
gearshift lever or the selector lever into the
“R” position.
3. Release the brake pedal and the hill start
assist will maintain the braking force ap-
plied while stopping for approximately 2
seconds.
4. Depress the accelerator pedal and the
hill start assist gradually will decrease
the braking force as the vehicle starts
moving.
NOTE
l
The hill start assist is activated when all of
the following conditions are met.
•
The engine is running.
(The hill start assist will not be activated
while the engine is starting or immediate-
ly after the engine is started.)
•
On vehicles equipped with M/T, the gear-
shift lever is in the following position.
[When starting an uphill slope forwards.]
The gearshift lever is in any position other
than “R”.
(The hill start assist will operate, even if
the gearshift lever is in the “N” position.)
[When starting an uphill slope back-
wards.]
The gearshift lever is in the “R” position.
(The hill start assist will not operate when
the gearshift lever is in the “N” position.)
•
On vehicles equipped with CVT, the se-
lector lever is in any position other than
“P” or “N”.
•
The vehicle is completely stationary, with
the brake pedal depressed.
•
The parking brake is released.
l
The hill start assist will not operate if the ac-
celerator pedal is depressed before the brake
pedal is released.
NOTE
l
The hill start assist also operates when re-
versing on an uphill slope.
Warning display
If an abnormal condition occurs in the sys-
tem, the following display/indicator will turn
on.
-
ASC indicator
Warning display type 1
Warning display type 2
NOTE
l
The combination of items shown on the dis-
play varies depending on the vehicle model.
Hill start assist*
6-34
OGAE19E1
Starting and driving
6