Mitsubishi ASX 2019

To turn on/off the system
You can switch the system from OFF to ON
or ON to OFF if you hold the FCM ON/OFF
switch pressed when the ignition switch is
turned to the “ON” position or the operation
mode is put in ON.
Once the system is turned on, the information
screen of the multi-information display
shows the collision alarm timing currently se-
lected, and the
indicator on the instrument
cluster goes out.
When you turn off the system, the following
message appears on the information screen of
the multi-information display and the indi-
cator will come on in the instrument cluster.
Cycling the ignition switch to the “ON” posi-
tion or putting the operation mode in ON will
set the FCM back ON.
To change alarm timing
Give a short press to the FCM ON/OFF
switch to change the timing at which the
frontal collision alarm is triggered. Every
time you press the switch, the alarm timing
changes from three levels (far, middle or
near).
As you make selection, the selected alarm
timing is displayed on the information screen
of the multi-information display. Even after
turning off the FCM, turning the ignition
switch to the “LOCK” position or putting the
operation mode in OFF, the system retains
your last selected alarm timing in memory.
Distance mode: Far
Distance mode: Middle
Distance mode: Near
CAUTION
l
For the FCM brake prefill, the FCM brake
assist and the FCM braking functions, the
function triggering timing cannot be
changed.
Forward Collision Mitigation system (FCM)*
6-51
OGAE19E1
Starting and driving
6