EasyManua.ls Logo

Mitsubishi ASX 2019

Mitsubishi ASX 2019
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If the display keeps showing the message,
there is a possibility that the FCM has a mal-
function. Contact a MITSUBISHI MOTORS
Authorized Service Point for inspection of
the system.
FCM deactivation due to fault
If the FCM detects a malfunction in the sys-
tem, either one of the following messages
will appear on the information screen of the
multi-information display, the
indicator
will come on in the instrument cluster and the
FCM will automatically be turned off.
If the message remains even after the ignition
switch is turned to the “LOCK” position and
then turned back to the “ON” position or the
operation mode is put in OFF, and then
turned back to “ON”, please contact a
MITSUBISHI MOTORS Authorized Service
Point.
NOTE
l
If the sensor or its surrounding area reaches
an extremely high temperature when parking
the vehicle under a blazing sun, the “FCM
SERVICE REQUIRED” message may ap-
pear.
After the temperature of the sensor or its sur-
rounding area has been in range, if the mes-
sage remains even after restarting the en-
gine, please contact a MITSUBISHI
MOTORS Authorized Service Point.
Handling of the sensor
The sensor (A) is located inside the wind-
screen as shown in the illustration.
The sensor is shared in the following sys-
tems:
l
Forward Collision Mitigation system
(FCM)*
l
Lane Departure Warning (LDW)*
l
Automatic High-Beam (AHB)*
CAUTION
l
To maintain proper performance of the FCM
and LDW;
Always keep clean the windscreen.
If the inside of the windscreen where the
sensor is installed becomes dirty or fog-
ged, contact a MITSUBISHI MOTORS
Authorized Service Point.
Do not apply an impact or load on the
sensor or its surrounding area.
Do not put anything including a sticker or
film to the outer side of the windscreen in
front of or surrounding area of the sensor.
Also, do not put anything including a
sticker or film to the inner side of the
windscreen under the sensor.
Do not attempt to detach or disassemble
the sensor.
If the windscreen is misted, remove the
mist from the windscreen by using the de-
mister switch.
Forward Collision Mitigation system (FCM)*
6-53
OGAE19E1
Starting and driving
6

Table of Contents

Related product manuals