The indicator will appear on the informa-
tion screen of the multi-information display.
To turn off the LDW, press the LDW switch.
The indicator on the information screen of
the multi-information display will then go
out. To return the LDW to “ON”, press the
LDW switch again.
Standby state
In the standby mode, the system is capable of
recognizing the lane in which your vehicle is
positioned and issuing audible warning when
your vehicle goes out of the lane.
The system automatically shifts from the
“ON” state to the standby state if all of the
following conditions are simultaneously met.
The
indicator on the information screen in
the multi-information display will be changed
to green.
l
The vehicle speed is approximately 65
km/h or higher.
l
The turn-signal lever is not operated.
l
The hazard lamp is not activated.
l
Environmental conditions are adequate
for the system to recognize the lane
markings on both sides.
l
The system has been placed in the “ON”
state.
NOTE
l
The system stays in the “ON” state for ap-
proximately 7 seconds after the hazard lamp
has stopped flashing or the turn-signal lever
has returned to the home position.
Lane departure warning
A buzzer sounds intermittently and the in-
dicator starts flashing in yellow when your
vehicle is about to leave or has left the lane in
the standby mode.
(green) (flashing in yellow)
NOTE
l
If the warning continues for approximately 3
seconds or more, the system switches to the
standby mode before the warning stops.
Lane Departure Warning (LDW)*
6-62
OGAE19E1
Starting and driving
6
To Next Page
Loading...
