The base tyre pressure can be set at desired
value by the driver with the reset function ex-
ecution. (The low pressure warning threshold
is set based on the reset.)
The tyre inflation pressure sensor IDs for two
sets of tyres can be registered by a
MITSUBISHI MOTORS Authorized Service
Point, and the valid ID set can be switched by
the multi-information meter switch (It’s bene-
ficial in case of seasonal tyre change between
summer tyre and winter tyre.)
WARNING
l
The spare wheel does not have a tyre in-
flation pressure sensor.
When the spare tyre is used, the tyre pres-
sure monitoring system will not work
properly.
See a MITSUBISHI MOTORS Author-
ized Service Point as soon as possible to
replace or repair the original tyre.
NOTE
l
The tyre pressure monitoring system
(TPMS) is not a substitute for regularly
checking tyre inflation pressures.
Be sure to check the tyre inflation pressures
as described in “Tyres” on page 10-11.
l
The tyre inflation pressure sensor (B) is in-
stalled in the illustrated location.
•
On vehicles with Type 1 sensor which has
the metallic air valve (C), replace grom-
met and washer (D) with a new one when
the tyre is replaced.
•
On vehicles with Type 2 sensor which has
the rubber air valve (E), replace rubber air
valve (E) with a new one when the tyre is
replaced.
For details, please contact your
MITSUBISHI MOTORS Authorized
Service Point.
NOTE
The tyre pressure monitoring
system warning lamp/display
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, the tyre pressure monitoring system
warning lamp normally illuminates and goes
off a few seconds later.
Tyre pressure monitoring system (TPMS)*
6-65
OGAE19E1
Starting and driving
6
To Next Page
Loading...
