CAUTION
•
The sensors or surroundings have been
wiped by hand, or stickers or accessories
have been attached.
l
The reversing sensor system may not proper-
ly detect the following:
•
Objects that are thin, such as wire nets or
ropes.
•
Objects that absorb sound waves, such as
snow.
•
Objects that are shaped with a sharp an-
gle.
•
Objects with a smooth surface, such as
glass.
•
Objects that are low, such as kerbstones.
NOTE
l
The buzzer may sound lower than the nor-
mal warning sound when the reversing sen-
sor system is receiving ultrasonic noise from
other sources, but this is not a malfunction.
The buzzer will stop sounding and the sys-
tem will return to normal operation after the
noise is no longer received.
To operate
To operate the system, move the gearshift
lever or selector lever to the “R” position
while the ignition switch or the operation
mode is in ON. When the reversing sensor
system is operated, the reversing sensor sys-
tem operation indication lamp (A) will turn
on. To stop the operation, push the “SONAR”
switch; the reversing sensor system operation
indication lamp (A) is turned off.
NOTE
l
Only when the gearshift lever or selector
lever is in the “R” position, the reversing
sensor system can be operated or be stopped
by using the “SONAR” switch.
Warning for obstacles
If there is an obstacle behind the vehicle, a
warning will be issued with the information
screen in the multi-information display and a
warning buzzer.
1- Corner sensor (left)
2- Back sensor
3- Corner sensor (right)
Corner sensor
Vehicle to obstacle
distance
Warning display/
sound cycle
Approx. 60 to 40 cm Intermittent
Approx. 40 to 20 cm Fast intermittent
Within approx.
20 cm
Continuous
Reversing sensor system*
6-72
OGAE19E1
Starting and driving
6