Mitsubishi ASX 2019

CAUTION
l
If there is any air left in the tyre when you
remove the valve insert, the valve insert may
fly out and injure you. Make sure the tyre
contains no air before removing the valve in-
sert.
8. Shake the tyre sealant bottle well.
NOTE
l
In cold conditions (when the ambient tem-
perature is 0 °C or lower), thickening of the
tyre sealant can make the tyre sealant hard to
squeeze out of the bottle. Warm the bottle in-
side the vehicle.
9. Take the cap (G) off the tyre sealant bot-
tle (H). Do not remove the seal (I).
Screw the filler hose (J) onto the bottle
(H). As you screw the filler hose onto
the bottle, the seal will break, allowing
the sealant to be used.
CAUTION
l
If you shake the bottle after screwing on the
hose, sealant may spray out of the hose.
10. Press the hose onto the valve (D). Hold-
ing the sealant bottle upside-down,
squeeze it again and again to inject all of
the sealant into the tyre.
NOTE
l
When injecting the sealant, position the
valve away from the bottom, i.e., away from
the point where the tyre touches the ground.
If the valve is near the point where the tyre
touches the ground, the sealant may not go
into the tyre easily.
11. After injecting the sealant, pull the hose
off the valve, remove any residual seal-
ant from the valve, rim and/or tyre. Fit
the valve insert (F) into the valve (D),
and screw the valve insert securely into
place using the valve remover (E).
Tyre repair kit*
8-09
OGAE19E1
For emergencies
8