Mitsubishi ASX 2019

CAUTION
l
Do not affix the sticker anywhere except the
specified position on the pad of the steering
wheel. Affixing the sticker in an incorrect
position could prevent the SRS airbag from
working normally.
l
Be sure to check the tyre pressure for confir-
mation that the emergency repair procedure
is complete.
18. When you have inflated the tyre to the
specified pressure, stow the compressor,
bottle, and other items in the vehicle and
promptly start driving the vehicle so that
the tyre sealant can spread evenly in the
tyre. Drive with great care. Do not ex-
ceed a speed of 80 km/h (50 mph). Ob-
serve local speed limits.
CAUTION
l
If you sense any abnormality while driving,
stop the vehicle and contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist. Otherwise the tyre pressure
may drop before the emergency repair pro-
cedure is completed, rendering the vehicle
unsafe.
NOTE
l
Driving faster than 80 km/h (50 mph) can
make the vehicle vibrate.
19. After driving for 10 minutes or 5 km
(3 miles), check the tyre pressure using
the air pressure gauge on the compres-
sor.
If the tyre pressure is not sufficient, in-
flate the tyre to the specified pressure
again and drive the vehicle carefully
without exceeding a speed of 80 km/h
(50 mph).
CAUTION
l
If the tyre pressure is lower than the mini-
mum permitted pressure (1.3 bar
{130 kPa}), the tyre cannot successfully be
repaired with the tyre sealant. Do not drive
the vehicle any further. Contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point or another specialist.
20. After driving for 10 minutes or 5 km
(3 miles), check the tyre pressure using
the air pressure gauge on the compres-
sor. If the tyre pressure has apparently
not dropped, the emergency repair pro-
cedure is complete. You must still not
exceed a speed of 80 km/h (50 mph).
Observe local speed limits.
NOTE
l
If the tyre pressure has dropped below the
specified level when you check it at the end
of the repair procedure, do not drive the ve-
hicle any further. Contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist.
l
In cold conditions (when the ambient tem-
perature is 0 °C or lower), the time and driv-
ing distance necessary until completion of
the repair can be longer than in warmer con-
ditions, meaning that the tyre pressure can
drop below the specified level even when
you have inflated the tyre a second time and
subsequently driven the vehicle. If this hap-
pens, inflate the tyre to the specified pres-
sure once more, drive for about 10 minutes
or 5 km (3 miles), then check the tyre pres-
sure again. If the tyre pressure has again
dropped below the specified level, stop driv-
ing the vehicle and contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist.
l
Please give the empty sealant bottle to your
MITSUBISHI MOTORS Authorized Serv-
ice Point when you purchase new sealant or
dispose of the sealant bottle according to na-
tional regulations for the disposal of chemi-
cal waste.
Tyre repair kit*
8-12
OGAE19E1
For emergencies
8