Mitsubishi ASX 2019

NOTE
l
For vehicles equipped with the mirror retrac-
tor switch, the outside rear-view mirrors au-
tomatically extend when all the doors and
tailgate are unlocked using the keyless oper-
ation function.
Refer to “Starting and driving: Outside rear-
view mirrors” on page 6-09.
l
Except for vehicles equipped with a Dead
Lock System, the keyless operation function
can be set so that only the driver’s door un-
locks when the driver’s door lock/unlock
switch is pressed.
If the keyless operation function is set to
work as described above, all the doors and
the tailgate unlock when the driver’s door
lock/unlock switch is pressed two times in
succession.
Refer to “Setting of door and tailgate unlock
function” on page 3-23.
l
The keyless operation function does not op-
erate under the following conditions:
•
The operation mode is not in OFF.
l
The doors and the tailgate cannot be un-
locked by using the tailgate OPEN switch
for about 3 seconds after locking.
l
The time within which locking confirmation
is possible can be adjusted. For further infor-
mation, please contact your MITSUBISHI
MOTORS Authorized Service Point.
l
The time between unlocking and automatic
locking can be adjusted. Consult a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Operation confirmation when locking and
unlocking
Operation can be confirmed as shown below.
However, the room lamp will only illuminate
if the front room lamp switch is in the
“DOOR” position or the rear room lamp
switch (except for vehicles equipped with the
sunshade) is in the middle (•) position.
When lock-
ing:
The turn-signal lamps will
blink once.
When un-
locking:
The room lamp illuminates
for approximately 15 sec-
onds, the turn-signal lamps
blink twice.
NOTE
l
Functions can be modified as stated below.
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
•
Set the confirmation function (blinking of
the turn-signal lamps) to operate only
when the vehicle is locked or only when
the vehicle is unlocked.
•
Disable the operation confirmation func-
tion (blinking of the turn-signal lamps).
•
Change the number of blinks for the oper-
ation confirmation function (blinks of the
turn-signal lamps).
Operation of the Dead Lock
System
With a vehicle that has a Dead Lock System,
it is possible to set the Dead Lock System us-
ing the driver’s or front passenger’s door
lock/unlock switch, or the tailgate LOCK
switch.
(Refer to “Dead Lock System” on page
3-26.)
Electronic immobilizer (Anti-
theft starting system)
The electronic immobilizer has been de-
signed to significantly reduce the possibility
of vehicle theft. The purpose of the system is
to immobilize the vehicle if an invalid start is
attempted. A valid start attempt can only be
achieved (subject to certain conditions) using
a keyless operation system “registered” to the
immobilizer system.
All of the keys provided with your new vehi-
cle have been programmed into the vehicle’s
electronics. Refer to “Engine switch” on page
3-13.
NOTE
l
If the engine does not start, contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Keyless operation system*
3-12
OGAE19E1
Locking and unlocking
3