Mitsubishi ASX 2019

WARNING
l
Check with a MITSUBISHI MOTORS
Authorized Service Point when it is neces-
sary to repair a high intensity discharge
headlamp or to replace the bulb.
High voltage is generated in the high in-
tensity discharge headlamp bulb and elec-
trodes, which may cause a severe shock
when the bulb and connector are removed
or disconnected.
Headlamps (High-beam)
1. Turn the cap (A) anticlockwise to re-
move it.
*: Front of the vehicle
2. Turn the cap (B) anticlockwise to re-
move it.
*: Front of the vehicle
3. While holding down the tab (C), pull out
the socket (D).
*: Front of the vehicle
4. To install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle halogen lamp bulbs with care. The
gas inside halogen lamp bulbs is highly pres-
surized, so dropping, knocking, or scratching
a halogen lamp bulb can cause it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the headlamps are op-
erated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc., and
refit it after drying it thoroughly.
Position lamps (type 1)
1. Turn the socket (A) anticlockwise to re-
move it.
Replacement of lamp bulbs
10-27
OGAE19E1
Maintenance
10