4. Remove the bulb by pulling it out.
5. To install the bulb, perform the removal
steps in reverse.
NOTE
l
When installing the lid, align the tab on the
lid with the hole on the vehicle side.
Licence plate lamps
1. When removing the lamp unit (A), push
it towards the left side of the vehicle
body.
2.
Remove the socket (B) and bulb assem-
bly by turning it anticlockwise.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal
steps in reverse.
NOTE
l
When installing the lamp, insert tab (C) first
then align and insert tab (D).
Replacement of lamp bulbs
10-32
OGAE19E1
Maintenance
10
To Next Page
Loading...
