1Error list
Error no. L2614
1-30
L2614 Error message Spline interpolation error (other functions)
Cause A function that cannot be used with the spline interpolation was executed.
Measures Refer to the error details No. and check the details of the occurring error. Then take actions for those
error details.
Error message Tracking function is enabled
Cause The tracking function was enabled when attempting spline interpolation.
Measures Spline interpolation and tracking function cannot be executed simultaneously. Disable the tracking function
before executing spline interpolation.
Error message Can't change tool/base setting
Cause The tool/base setting was changed during spline interpolation execution.
Measures The tool/base setting cannot be changed during spline interpolation (including when halted). Change the
settings after spline interpolation ends.
Error message Can't execute Jrc command
Cause The Jrc command was executed during spline interpolation.
Measures The Jrc command cannot be executed during spline interpolation (including when halted). Execute the
command after spline interpolation ends.
L2615 Error message Spline interpolation error (exceeds setting range)
Cause A setting value related to spline interpolation exceeds the setting range.
Measures Refer to the error details No. and check the details of the occurring error. Then take actions for those
error details.
Error message M_SplVar setting value exceeds setting range
Cause A value exceeding the range was substituted into M_SplVar.
Measures Substitute a value within the setting range (0 to 32767).
Error message M_SplVar setting range exceeds setting range (nnnn)
Cause A value exceeding the setting range is set in the spline file.
Measures Change the setting for the path point No. "nnnn" indicated in the error message so it is within the range (ā
1 to 32767).
Error message Tolerance setting value exceeds range (nnnn)
Cause The tolerance designation in the spline file exceeds the range.
Measures Change the tolerance designation for the path point No. "nnnn" indicated in the error message so it is
within the range (0 to 100).
Error message Output signal exceeds range (nnnn)
Cause The head No. for the signal output in the spline file exceeds the range.
Measures Change the head No. of the signal output for the path point No. "nnnn" indicated in the error message so it
is within the range (ā1 to 32767).
Error message Interpolation setting information exceeds range
Cause Data with value exceeding the range was found in the spline file interpolation setting information.
Measures Open the target spline file and check the contents. Then, save the file again to recreate the spline file.
Write the new file to the controller again.
Error message Header information exceeds range
Cause Data with value exceeding the range was found in the spline file header information.
Measures Open the target spline file and check the contents. Then, save the file again to recreate the spline file.
Write the new file to the controller again.
L2621 Error message Tracking function is enabled.
Cause The tracking function and Ex-T control function cannot be enabled simultaneously.
Measures When using the Ex-T control function, disable the tracking function.
L2622 Error message Singular point passage function is enabled.
Cause The singular point passage function and Ex-T control function cannot be enabled simultaneously.
Measures When using the Ex-T control function, disable the singular point passage function.
Error No. Error cause and measures
To Next Page
Loading...
