1Error list
Error no. L3361
1-36
L3361 Error message Can not load the program (SLT*)
Cause A non-existing program was specified in the slot parameter (SLTn).
Measures A non-existing program was specified in the slot parameter (SLTn).
L3370 Error message Cannnot execute XClr (empty)
Cause XClr is not possible as the program has not been selected.
Measures XClr can only be executed to enable program selection.
L3380 Error message Cannnot execute XClr (not PSA)
Cause Program selection is not enabled.
Measures Execute XClr after resetting the program (canceling the abort status).
L3390 Error message Cannot use arc pallet
Cause Cannot use arc pallet.
Measures Change to another method.
L3400 Error message System error (PROC stack over)
Cause System error. (Processor stack overflow)
Measures If it comes back, contact your service provider
L3500 Error message Illegal format input (Input)
Cause The type of the variable specified by Input and the type of the received data do not match.
Measures Check the format.
L3501 Error message Illegal Receive data (EBREAD)
Cause Type is different (receive data and specified variable)
Measures Please confirm specified tag data of the vision.
L3600 Error message Jump destination does not exist
Cause No jump destination was found for the Def Act, On Com and On GoTo commands.
Measures Check the jump destination.
L3700 Error message Undefined variable
Cause It was attempted to reference a variable that has not been initialized.
Measures Define a variable, enter an initial value, and then use it.
L3710 Error message Nesting over (CallP)
Cause Program Call is used more than the limitation.
Measures Reduce the call count of CallP (nesting).
L3720 Error message RC NX statements unmatch
Cause RC NX statements unmatch
Measures Match the numbers of RC and NX.
L3750 Error message Illegal positions (Def Plt)
Cause Multi rotation flag (FL2 J1/J4 axis) is different
Measures Specify position to become the same multi rotation flag.
L3760 Error message Illegal positions (Def Plt)
Cause J1 or J4 axis is greatly changed (Def Plt)
Measures Specify positions to be not different greatly
L3770 Error message This is an undefined Mo trigger.
Cause An attempt was made to use an undefined Mo trigger.
Measures Define the specified Mo trigger before use.
L3810 Error message Different argument type
Cause The type of an argument in an arithmetic operation, monadic operation, comparison operation or each func
-
tion is different.
Measures Designate the correct argument.
L3820 Error message Undefined intermediate code
Cause A program or system status variable may have been damaged.
Measures Restore using the backup data. If the backup data is not available, it is necessary to create a program again.
Error No. Error cause and measures
To Next Page
Loading...
