1-53
Error no. L8630
1Error list
L8630 Error message The recognition cell is illegal
Cause There is no value on the cell
Measures Please check the recognition cell
L8631 Error message The cell is outside the range
Cause The range of the cell is exceeded
Measures Please check the range of the cell
L8632 Error message The vision is a time-out
Cause There is no response from the vision
Measures Please check the time-out time
L8633 Error message The vision is a time-out (NVTRG)
Cause There is no response from the vision (NVTRG)
Measures Please decrease the load of the network
L8634 Error message There is a comma within the range of the cell
Cause There is a comma within the range of the cell
Measures Please check the range of the cell
L8635 Error message There is no comma within the range of the cell
Cause There is no comma within the range of the cell
Measures Please check the range of the cell
L8636 Error message Vision Tag name is abnormal
Cause There is no specified vision tag in the vision program
Measures Please correct the vision tag name
L8640 Error message The image trigger is abnormal
Cause The trigger setting of the vision sensor is abnormal
Measures Please check the trigger setting
L8650 Error message Please make the vision online
Cause The vision sensor is off-line
Measures Please make vision sensor online
L8660 Error message There is no authority
Cause The authority of the user-name is not a full access
Measures Please check user name
L8670 Error message Can not restart
Cause It started without resetting it
Measures Please reset the program
L8680 Error message Unknown code was received (code no.)
Cause Status code of unregistration was received from vision sensor.
(Status cord which is not registered with robot controller was received.)
Measures The status code received from vision sensor is displayed to the code no..
When the code no. is not the numerical value, there is a possibility which received abnormal data.
Please check the communication state, the communication setting, and the command argument.
L8700
(CR7xx-Q
only)
Error message Multi CPU system self-check error
Cause Illegal parameter of multi CPU system and CPU is abnormal,etc.
Measures Confirm details and measures of the error with GX Developer etc.
L8710 Error message PC I/O module parameter(m) error.
(m): Target parameter numbers 1-4. (correspond to QXYUNIT 1-4)
Cause An illegal setting of the PC I/O module was detected.
Measures Please check the value of parameter.
L8720 Error message Fuse is blown.(PC I/O module (m)).
(m): Target parameter numbers 1-4. (correspond to QXYUNIT 1-4)
Cause Fuse is blown.(PC I/O module)
Measures Please refer to the manual of PC I/O module.
Error No. Error cause and measures
To Next Page
Loading...
