PARAMETERS
180
1) When not adjusting the gain voltage
→
go to (5)
2) When adjusting any point by applying a voltage
→
go to (6)
3) When adjusting any point without applying a voltage
→
go to (7)
(5)How to adjust the gain frequency only without the voltage being adjusted
Press for 1.5 s
SET
Flicker
!!
Press the or key once to display
the current analog voltage adjustment.
Example:
When analog voltage
adjustment value is 100%(5V)
FR-DU04
CONTROL PANEL
Hz
MON EXT PU
A
V
REV FWD
Analog voltage A/D value (%)
across terminals 2-5
SET
(6)How to adjust any point by applying a voltage across terminals 2-5 (e.g. from the external
potentiometer) (current: across terminals 4-5) (When applying 5V)
SET
Press for 1.5 s
Flicker
!
!
Apply a 5V voltage.
(Turn the external potentiometer
connected across terminals 2-5 to maximum.)
When the potentiometer is
at the maximum position,
the v
alue is nearly 100.
FR-DU04
CONTROL PANEL
Hz
MON EXT PU
A
V
REV FWD
Analog voltage A/D value (%)
across terminals 2-5
(7)How to adjust any point without applying a voltage across terminals 2-5 (without a current flowing across
terminals 4-5) (when changing from 4V (80%) to 5V (100%))
!
Set the
ain volta
e
%
with
the key.
[0(%) for 0V (0mA), 100(%) for
5V (10V, 20mA)]
Press for 1.5 s
Flicker
!
!
Press the or key
once to display the current
analog voltage calibration value.
FR-DU04
CONTROL PANEL
Hz
MON EXT PU
A
V
REV FWD
Analog voltage A/D value (%)
across terminals 2-5
SET
(8)Press the
SET
key to shift to the next parameter.
(9)Re-set Pr. 79 "operation mode selection" according to the operation mode to be used.
To Next Page
Loading...
