Mitsubishi FREQROL-SFJ - Page 73

(3)
To remove the bear-
ing on the counter-
load side, remove
the shaft stop ring
and apply a bearing
remover.
The bearing can be
removed together
with the shaft case
cover.
Stop'ring for shaft
(4) To remove the bear-
ing on the load side,
apply a bearing re-
mover to the inner
ring of bearing and
turn the handle of
bearing remover.
(5) To install bearing to
shaft,
all fitting sur-
faces should be thorough-
ly cleaned and smoothed.
(6) Apply grease to bearing
bore surface and shaft.
Put a pipe on the bear-
ing inner ring and care-
fully depress the bearing
by a press machine.
press here.
Pipe
,Bearing
Press machine is used to
install bearing.
- 70 -