12-20 Simple inspection and service
1.2 Checking by use of oil level gauge
• Preparation
<Vehicles other than Crew-cab models>
1. Tilt the cab.
<Crew-cab models>
1. Open the inspection cover in the rear floor
mat.
2. Release the lock , then open the hatch .
3. After inspection, close the hatch and inspection
cover by following the opening sequence in
reverse.
Observe the following caution, which is also printed
on the caution plate .
CAUTION
INSPECT CAREFULLY AS THIS COVER AND
INSIDE MAY BE EXTREMELY HOT.
• Checking
1. Remove oil level gauge and wipe off oil with a
cloth.
2. Fully insert the oil level gauge in the crankcase,
and gently draw it out.
3. The oil level marked on the oil level gauge
should be between the upper and lower
notches.
If necessary, replenish with the recommended
engine oil.
If the engine oil is extremely dirty, replace it.
4. After the check, insert the oil level gauge into
position and secure it properly.
<Crew-cab models>
Z12037
Z12038
<Vehicles other than Crew-cab models>
Z10725
FEFG.book Page 20 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
