13-8 Useful advice for emergencies
• The fuse box is located under the center panel.
Fuses are also located in the high-current fuse
box.
• If a lamp fails to illuminate or electrical equip-
ment does not function, a fuse may have blown.
Check and replace fuses as necessary.
• Before checking or replacing fuses, turn the
starter switch to the “LOCK” position and push
all switches to the OFF position.
1 Removal and installation of fuse box
cover
1. Pull the bottom of the fuse box cover toward
you to remove the cover.
2. To install the cover, align and insert the tabs
at the top then press the bottom of the cover into
place.
2 Removal and installation of high-current
fuse box cover
1. Pull down the clamps , then lift the cover
straight upward to remove it.
2. To install the cover, place it on the box and press
it straight downward. Align the holes of the clips
with the protrusions . While still pressing the
cover downward, retain it with the clamps.
CAUTION
When installing the high-current fuse box cover,
be sure to retain it with the clamps while press-
ing it straight downward. Pushing the cover
toward the inside of the vehicle with excessive
force could break it.
When a fuse has blown
Z11215
Z12080
FEFG.book Page 8 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
Need help?
General
