13-9
3 Fuse replacement
1. To remove the fuse that is to be replaced, grip it
using the fuse puller in the fuse box. The
amperage and protected circuit of each fuse are
shown on the inside of the fuse box cover and
on the inside of the high-current fuse box cover.
2. If a fuse is blown, be sure to select a spare fuse
of the specified amperage for replacement.
CAUTION
• If the cause of a blown fuse cannot be deter-
mined or the same fuse blows frequently,
have an authorized dealer perform neces-
sary inspection.
• Use care not to splash water on or around
the fuse box cover. Should water be
splashed over the fuse box cover, check the
inside of the fuse box for water.
WARNING
Be sure to use fuses of the specified amper-
ages.
A fire could result if a fuse of incorrect
amperage is used.
Z11260
Z11217
FEFG.book Page 9 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
Need help?
General
