12-28 Simple inspection and service
5.1 Check
1. Remove inspection plug and make sure that
the oil is topped off.
2. If insufficient, add oil through the inspection plug
hole until it is full to the brim.
CAUTION
The added oil should be of the same grade and
viscosity as the oil originally placed in the dif-
ferential gears.
3. Install the inspection plug.
5.2 Replacement
1. Remove inspection plug and drain plug to
let the oil flow out.
NOTE:
Oil removal is quicker if performed not so long after
the vehicle has been stopped and while the oil is
still warm.
2. The drain plug is fitted with a magnet. Wipe off
any metal particles sticking to the magnet and
install the drain plug.
3. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
4. Install the inspection plug.
6Brake fluid
Have the brake fluid replacement performed by an
authorized dealer.
Tightening
torque
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
WARNING
The gear oil is extremely hot immediately
after the vehicle has been operated. Take
care to avoid being scalded when draining
hot oil. Give the oil time to cool before drain-
ing it.
Tightening
torque
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
Tightening
torque
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
Inspection
intervals
At the time of pre-operational
check
Replacement
intervals
Every 50,000 km (30,000 miles)
or every 24 month
Z09245
FEFG.book Page 28 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
Need help?
General
