EasyManua.ls Logo

Mitsubishi FUSO FE 2006 - Automatic Transmission Fluid

Mitsubishi FUSO FE 2006
309 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12-24 Simple inspection and service
4. Install the inspection plug.
3 Automatic transmission fluid
Recommended fluid:
Automatic transmission fluid
(Exxon Mobil: Mobil ATF3309 or equivalent)
Have the automatic transmission oil changed by an
authorized dealer.
3.1 Checking
NOTE:
Inspection of the fluid level should be carried out
when the fluid is at a high temperature after driving
and with the level gauge indicating “HOT”. The
“COLD” level is for reference purposes when the oil
temperature is low, and accurate measurement will
not be possible if the fluid temperature is low.
1. Park the vehicle on level ground. Prevent the
vehicle from moving by pulling the parking brake
lever and blocking the wheels with chocks.
2. Start the engine. With the engine idling and
brake pedal depressed, select each gear range
in turn, then put the range selector lever in the
“P” position.
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
Inspection intervals
Every 10,000 km
(6,000 miles)
Replacement intervals
Every 40,000 km
(24,000 miles)
Z12049
Level gauge
<Crew-cab models>
<Vehicles other than Crew-cab models>
FEFG.book Page 24 Thursday, March 10, 2005 7:30 PM

Table of Contents

Related product manuals