12-8 Simple inspection and service
4. Push down lever B until the pin engages
with the latch . Check that lever B cannot be
pulled up.
5. Turn the starter switch to the “ON” position, and
make sure that the warning lamp is not lit.
If the warning lamp lights and the buzzer
sounds, the cab is not locked completely. If this
happens, tilt up the cab, lower it, and lock it
again.
Be sure to perform the pre-operational checks for
the items listed below at the start of each day’s
operation in order to ensure safe and comfortable
driving. If you find anything unusual which you are
unable to repair yourself, you should have this cor-
rected at an authorized dealer before operating the
vehicle.
1 Before starting the engine
WARNING
If the lever B cannot be pushed down, tilt up
the cab again and repeat the lowering proce-
dure from the beginning.
Pre-operational checks
Z10678
Z11895
Z11896
FEFG.book Page 8 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
Need help?
General
