12-55
1 Preparation for tire replacement
•
Park the vehicle on a flat, hard surface. Pull the
parking brake all the way on. If your vehicle has
a manual transmission, place the gearshift lever
in the neutral position. If your vehicle has an
automatic transmission, place the range selec-
tor lever in the “P” position.
• Be sure to stop the engine.
• If you get a flat tire while on the road and need
to change it on the spot, pull up your vehicle in a
safe place where it will not block traffic, and
cause your hazard warning lamps to flash and
use a red or white flag or cloth to give warning to
passing vehicles.
• Have all passengers get out of the vehicle.
• Block the tire diagonally opposite to the tire to
be replaced with a chock.
Example:
Block the left front tire if the right rear tire is to be
replaced.
• Prepare a replacement tire.
NOTE:
• Your vehicle is not provided with a replacement
tire as standard equipment.
• Applicable tires are as follows.
2 Removing the wheel
2.1 Front axle jacking points
• FE
Bottom surface of the leaf spring at the rear of tie
rod.
Tire replacement
Model Tire size
FE84
LT215/85R16-10PR
(Load Range E)
FE85
215/75R17.5 124/123L
(Load Range F)
FG
LT235/85R16-10PR
(Load Range E)
Z12085
FEFG.book Page 55 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
Need help?
General
