5-4 Switches and controls
• LOCK
The starter key can be inserted and removed
in this position only. To place the key in the
“LOCK” position, turn it to the “ACC” position
then press it in. Keep it pressed in while turning
it to the “LOCK” position. When the key is
removed, the steering wheel locks.
The lighting switch, rheostat control switch, haz-
ard warning lamps, interior lamp, horn, central
door locks and turn signal lamps can be used.
• ACC
The engine is shut off or is not running in this
position.
The cigarette lighter can be used. Audio equip-
ment (radio, etc.) installed and connected in the
approved manner can also be used.
• ON
The engine is running in this position.
All electrical circuits are operable.
• START
The engine is turned over and started in this
position.
Once the engine is running, release the key and
the switch will automatically return to the “ON”
position.
NOTE:
• Turn the key only after inserting it fully in the
starter switch.
• If you are unable to turn the key, gently turn the
steering wheel clockwise and counterclockwise
as you turn the key.
• To warm up the engine quickly or make the
heater work more effectively with the vehicle
stationary, turn ON the warm-up switch . The
warm-up system will begin to operate, and the
indicator lamp will illuminate.
P. 5 - 10
• When the engine has finished warming up, the
warm-up system stops operating automatically
and the indicator lamp turns off.
• Once the engine has warmed up and/or the
heater is working satisfactorily, turn OFF the
switch.
Warm-up switch
Z10782
Z11822
FEFG.book Page 4 Thursday, March 10, 2005 7:30 PM