4-5
• Fastening
1. Hold tang and gently extend the belt. If the
belt locks or is difficult to extend, let it retract and
pull it gently again.
2. Take care that the belt does not become twisted.
Insert the tang into the buckle until you hear a
click.
3. Pull on the tang to confirm that it is locked in.
4. Adjust the belt so it is across your hips and
shoulder.
• Unfastening
1. Press the red button to unlock the buckle.
2. The belt automatically retracts when unlocked.
To prevent the tang causing damage or injury,
hold it while the belt retracts.
3. Adjust the tang stopper to locate the tang in
an easy-to-reach position and prevent it from
slipping.
2Lap belt
•
Fastening
1. Take care that the belt does not become twisted.
Insert the tang into the buckle until you
hear a click.
2. Pull on the tang to confirm that it is locked in.
3. Adjust the belt so it is low across your hips.
4. To adjust the belt’s length, hold the tang at 90°
to the belt.
Pull the belt end to shorten the belt or the tang
to lengthen it.
To lengthen
To shorten
WARNING
For maximum protection in the event of an
accident, the belt must not be loose. A loose
belt could even aggravate injuries.
Z10760
Z11726
Z01351
Z08774
FEFG.book Page 5 Thursday, March 10, 2005 7:30 PM