12-23
Quantity required:
2.1 Check
1. Remove inspection plug and make sure that
oil is topped off.
2. If insufficient, add oil through the inspection plug
hole until it is full to the brim.
CAUTION
The added oil should be of the same grade and
viscosity as the oil originally placed in the trans-
mission.
3. Install the inspection plug.
2.2 Replacement
1. Remove inspection plug and drain plug to
let the oil flow out.
NOTE:
Oil removal is quicker if performed not so long after
the vehicle has been stopped and while the oil is
still warm.
2. The drain plug is fitted with a magnet. Wipe off
any metal particles sticking to the magnet and
install the drain plug.
3. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
Model Quantity
5-speed transmission
Approx. 3.6 liters
(3.8 qts)
6-speed transmission
Approx. 4.4 liters
(4.6 qts)
WARNING
Do not check or replace the gear oil immedi-
ately after operating the vehicle since the
engine, transmission, exhaust pipe, and
other components will be extremely hot.
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
WARNING
The gear oil is extremely hot immediately
after the vehicle has been operated. Take
care to avoid being scalded when draining
hot oil. Give the oil time to cool before drain-
ing it.
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
Z10770
FEFG.book Page 23 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
