12-57
3. Slightly loosen the wheel nuts by turning them in
the illustrated direction. Do not remove the nuts.
For right-hand wheel
For left-hand wheel
NOTE:
The wheel nuts on the right-hand wheel are marked
with “R” and have right-hand threads. Those on the
left-hand wheel are marked with “L” and have left-
hand threads.
4. Jack up the vehicle until the tire is just clear of
the ground.
5. Remove the wheel nuts and then the tire.
6. To remove the tires of a rear dual-wheel, first
loosen the outer wheel nuts and remove outer
tire ; then lower the jack, loosen inner wheel
nuts and jack up the vehicle again to remove
inner tire .
WARNING
• Fit the socket wrench securely on the
wheel nut. If fitted improperly, the wrench
will slip off the nut, and could cause injury.
• Do not loosen the wheel nuts too much or
you could damage the threads.
WARNING
• Do not rotate the jacked-up wheel if the
vehicle has a limited-slip differential.
Power would be transmitted to the wheel
in contact with the ground, and the vehicle
could move as a result.
• When removing wheels, be careful not to
damage the wheel bolts and the threads of
the inner wheel nuts.
Z12084
Z09307
Z09031
FEFG.book Page 57 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
Need help?
General
