4-3
1.2 Making adjustments
• Slide seat forward or backward while holding
slide adjustment lever raised. After making
the adjustment, release the lever and move the
seat back and forth slightly to lock it in position.
• To adjust the angle of the seatback , raise
reclining lever .
• Lower the armrest to use it. Turn the armrest
knob to adjust the height of the armrest in its
lowered position.
Up
Down
2 Assistant driver’s seat
Assistant driver’s seat
Center seat
• Pulling the seatback lever allows the seat-
back angle to be adjusted. With the lever pulled,
grasp the top of the seatback and move it for-
ward or backward to adjust the seatback angle
as desired.
After adjusting the seatback angle or returning
the seatback to its original position after tipping
it forward, gently rock the seatback to make sure
it is locked in place.
• It is possible to tip the seatback fully forward.
With the lever pulled, grasp the seatback at the
top and tip it forward.
3 Rear seat – Crew-cab models
Storage compartments are located under the rear
seat. The rear seat can be folded up for access to
them. When you wish to stow or remove something
from these compartments, release the hooks at
the base of the seat and raise the seat cushion .
To retain the seat cushion, use the retaining bands
that are attached to the seatback. Fit the loop
at the end of each retaining band over the corre-
sponding hook on the seat cushion.
Z10741
Z11806
Z12099
FEFG.book Page 3 Thursday, March 10, 2005 7:30 PM
To Next Page
Loading...
