5-46 Switches and controls
NOTE:
• The transmission PTO delivers power taken
from the truck’s transmission to a hydraulic
pump or other equipment/implement.
• Both automatic DPF regeneration and parked
DPF regeneration do not work while the PTO is
being used.
• will be indicated and a buzzer will sound to
warn you if you place the gearshift lever in any
position other than “P” or “N” while the PTO is
engaged or if you press the PTO switch while
driving.
1 Control and indicators
PTO switch
Use this switch to engage and disengage the PTO.
Indicators displayed on multi-information
display
• is displayed while the transmission PTO is
being engaged.
• is displayed when the transmission PTO has
been engaged.
1.1 Engagement
1. Confirm that the parking brake is firmly applied.
2. Confirm that the gearshift lever is placed in the
“P” position.
3. Start the engine while depressing the brake
pedal. After the engine has warmed up, let the
engine idle.
4. Make sure the indicator lamp is not flashing.
If it is flashing, perform parked DPF regenera-
tion before going to the next step.
5. Press the “ON” side of the PTO switch.
6. The multi-information display indicates .
Once the PTO has been engaged, the indicator
on the screen is replaced by .
NOTE:
The indicator may not be displayed under cer-
tain conditions. This does not indicate a problem.
Z21732
Z21733
Z21734
FE_FG.book Page 46 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
