5-41
CAUTION
Placing the gearshift lever in the “N” position
temporarily deactivates the cruise control. How-
ever, such practice is dangerous during driving
because engine braking will no longer be possi-
ble. It will also cause malfunction of the trans-
mission.
7 To reactivate the temporarily deacti-
vated cruise control
•
To reactivate the cruise control, turn the SET/
RESUME switch toward the “RESUME” side.
The indicator lamp will illuminate again and
the vehicle will resume running at the set speed.
• To reactivate the cruise control while altering the
set speed to a new speed, turn the SET/
RESUME switch toward the “SET” side when
the vehicle has reached the desired speed. The
indicator lamp will light up, and the vehicle
will continue running at the set speed.
NOTE:
Under any of the following conditions, you cannot
resume the set speed by performing the above
operation. In these situations, perform the speed
setting procedure from the beginning.
• The vehicle speed is lower than 30 km/h (18
mph).
Z21529
Z21526
FE_FG.book Page 41 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
