10-20 Interior equipment and accessories
• To tune to a preset station, use either of the fol-
lowing methods:
• Press one of the preset buttons “1” to “6”.
• Press the “PS/AS” button. The radio will
automatically tune to a preset station and
receive signals from the station for 10 sec-
onds before tuning to the next preset station.
Press the button a second time during the
10-second period to stay tuned to a desired
station.
• To tune to a non-preset station, press the “ ”
or “ ” button.
• The display indicates “ST” when tuned to a ste-
reo broadcasting station.
4. Adjust the volume using the power/volume
knob.
5. Make the fader, balance and tone adjustments
using the “SOUND” button and power/volume
knob.
3.2 Manual tuning
Use the “ ” or “ ” button.
: Press this button for higher frequencies.
: Press this button for lower frequencies.
If you keep pressing one of these buttons, the fre-
quency changes quickly upward or downward.
3.3 Automatic tuning using the “ ” and “ ”
buttons
Give the “ ” or “ ” button a long press (more
than 1 second) and then release it.
After a short beep, the radio starts automatic tuning.
It will then stay tuned to the first station with good
reception.
: Press this button for higher frequencies.
: Press this button for lower frequencies.
NOTE:
Use manual tuning if you cannot tune to a desired
station by automatic tuning due to poor signal
reception.
Z21075
Z21763
FE_FG.book Page 20 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
