EasyManuals Logo

Mitsubishi FUSO FE 2012 User Manual

Mitsubishi FUSO FE 2012
481 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #272 background imageLoading...
Page #272 background image
12-33
7. Like with the drain plug, replace the gasket of
the inspection plug with a new one, coat the
plug’s threads with the specified sealant, and
then install and tighten the plug.
5 Axle housing gear oil
Recommended oil:
Gear oil
API classification GL-5
Below 40°C (104°F) SAE90
40°C (104°F) or higher SAE140 or 85W-140
CAUTION
Use oil conforming to GL-5, SAE140 or
SAE85W-140 if the vehicle is to be driven
under heavy load conditions as for example
driving up long uphill grades. Remember,
however, that this oil is to be used only when
the temperature is higher than 10°C (50°F).
On vehicles with a limited slip differential, fill
the differential with Genuine Gear Oil, Part
No. 8149630EX (GL-5, SAE90).
Quantity required:
These oil quantities are given only as guidelines. Be
sure to check the correct oil level by removing the
inspection plug as indicated below.
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
Replacement intervals
Every 60,000 km
(36,000 miles) or every
24 months
Model Quantity
FE Approx. 4.5 liters (4.8 qts)
FG
Front axle Approx. 3.0 liters (3.2 qts)
Rear axle Approx. 4.5 liters (4.8 qts)
FE_FG.book Page 33 Tuesday, February 8, 2011 4:00 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi FUSO FE 2012 and is the answer not in the manual?

Mitsubishi FUSO FE 2012 Specifications

General IconGeneral
BrandMitsubishi
ModelFUSO FE 2012
CategoryAutomobile
LanguageEnglish

Related product manuals