5-30 Switches and controls
5.2 Reversing
1. While holding the brake pedal fully depressed,
place the gearshift lever into the “R” position.
2. Check that the gear position indicator shows
“R”.
NOTE:
• While the vehicle is moving, the reverse gear
does not engage even if you place the gearshift
lever into the “R” position. Always place the
gearshift lever into the “R” position when the
vehicle is stopped.
• Reverse gear engagement is still in progress
when the indication on the gear position indica-
tor is flashing. Do not release the brake pedal at
this time.
3. Release the parking brake. Slowly depress the
accelerator pedal while gradually releasing the
brake pedal to reverse the vehicle.
6Driving
It is recommended to use the automatic shift mode
for ordinary driving to reduce your workload.
CAUTION
• Never place the gearshift lever into the “N”
position while driving. This could result in an
accident as engine braking is not available,
and could damage the transmission.
• Use the manual shift mode when driving on
slippery surfaces (such as a wet or frozen
road). Using the automatic shift mode on
slippery roads could cause an accident for
the following reasons:
Skidding is more likely to be caused by auto-
matic shift-downs that take place normally
when driving in the automatic shift mode.
Skidding also may occur easily due to auto-
matic shift-downs following full or quick
operation of the accelerator pedal.
Even while driving using the manual shift
mode, the vehicle is likely to skid if you sud-
denly depress the accelerator pedal or
quickly shift down the gear.
Z21541
FE_FG.book Page 30 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
