12-82 Simple inspection and service
1 Removal and installation of battery
cover
1. Release the cover from the stopper by press-
ing the part of the cover that is marked with an
arrow in the illustration.
2. Pull the cover toward you to release it from the
other stoppers .
3. To fit the battery cover, perform these steps in
reverse. After fitting the cover, make sure it is
securely retained.
Battery – check
Inspection
intervals
At the time of pre-operational
check
WARNING
• The battery generates flammable hydro-
gen gas and should be kept away from
open flame and spark.
• When removing the battery, always dis-
connect the negative (–) terminal first and
reconnect it last. A spark can occur if a
tool touches the positive (+) terminal and
frame with the negative (–) terminal con-
nected.
• When handling the battery, wear safety
goggles to protect your eyes.
• Perform all battery checks with the engine
turned off.
Z18864
FE_FG.book Page 82 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
